More about Replacing Faucets!
People often replace faucets for a huge variety of reasons. There are several things to be aware of when choosing a new faucet. The existing hole patterns of the old faucet should match the hole patterns of the new faucet. If there is any doubt about the pattern, take the old faucet with you to the store or carefully measure the hole placement so you can find the ideal replacement when shopping online, at a place such as www.MasterFaucet.com
Step #1: Always cut off the water supply at the shut off valves. You will be amazed at how man guys forget this step! These shut off valves are usually found under the sink. If you cannot cut the water off under the sink, then go to the water main serving the entire home from outside at the main water valve.
Step #2: Carefully remove the supply lines with a crescent wrench. Some water will be left in the lines so use a catch basin or bucket to prevent from spilling that water everywhere.
Step #3: With the supply lines disconnected, you can now remove the faucet by releasing the nuts under the counter top. Use a basin wrench to do this because it is a very tight and confining area to work in. If the nuts are too difficult to remove, then you can use a penetrating oil to loosen the nuts. Then you can disconnect the other end of the supply lines and lift the faucet out after removing the nuts.
Please note: The pop-up stopper in the sink will also need to be disconnected before you will be able to remove the faucet. The three most common assemblies are:
1. Those that sit on top of the pivot rod and simply lift out.
2. The type that require a twist to free them because of a slot that hooks the body to the arm.
3. Then those where the stoppers are attached with a pivot rod. The pivot rod is released by loosening a clevis screw on the lift rod assembly.
Know which type of stopper you have. It is a good idea to draw a diagram when disconnecting the stopper to help you remember when it comes to the reassembly.
Step #4. Apply PTFE tape to prevent leaks at each new nipple. Always check the new faucet for a gasket. If the new faucet does not have a gasket, then you should use plumber's putty to create a seal.
Step #5. Replace the basin nuts and attach the supply lines. Always check the seat of the lines. Make sure the brass washer is in good shape and fits down properly before tightening the supply line nuts.
That should do it…you can Master the Faucet replacement, and when you need new faucets or information, please visit www.MasterFaucet.com the only kitchen and bathroom website you'll ever need!
See Our Bathroom Ideas Gallery !
|
