A sure first sign that you water softener is in need of attention would be the sudden appearance of some unsightly salt streaks on your newly cleaned glassware. Before you try to clean your water softener, be sure that you read the owner's instruction manual so that you will know where everything is.
To make sure that no water will go though the softener while you are working on it, make certain that you switch it to the bypass mode.
Be sure to un-plug the softener from the mains
Carefully remove the water softener injector cap, and put it to one side in a safe spot.
Removing the water softener injector cap will expose the injector screen which sits behind it.
Remove the injector screen and gently wash it thoroughly with warm soapy water.
Completely clean the water softener injector nozzle and clean out all of the dirt that has accumulated around it.
Replace the injector screen to its position over the nozzle.
Screw the injector cap back and place it onto the screen and then tighten it securely but carefully, don't break it of course.
Plug the softener back in to the mains again, switch it out of bypass mode and then you can test it and make sure that it is working properly.
To keep the water softener working at the best possible rate of efficiency, be sure that you clean the injector nozzle twice each year.
Whenever you need anything that is bathroom or kitchen related, always first visit the incredible website and online store of www.MasterFaucet.com where the selection and prices will amaze you!
